A spiral that stays balanced as it grows

A new interactive explanation from Evil Genius Labs shows why LED boards arranged on a Fermat spiral can remain evenly filled at many different pixel counts. The November 18 demonstration links two placement rules—the golden angle and a radius based on the square root of each LED's sequence number—to the familiar spiral patterns seen in sunflowers.

In the design, LED number `n` is rotated by `n × 137.508°` from the starting direction and placed approximately `√n` units from the center. The result differs from the popular "Fibonacci spiral" drawn through a sequence of adjoining squares. Here, every LED is a separate point on a Fermat spiral, producing a round field that can be stopped at different sizes without rearranging earlier pixels.

The angular choice prevents obvious spokes. Simple fractional turns repeatedly place points on the same lines: a 90-degree increment produces four spokes, while 120 degrees produces three. Even a close-looking value such as 137.5 degrees equals 55/144 of a full turn, so sufficiently large layouts eventually reveal crowding.

The golden angle is approximately `360° ÷ φ²`, or 137.508 degrees. Because it is maximally resistant to simple fractional representation, successive points avoid repeatedly aligning in the same directions. The demonstration notes that only a limited number of decimal places is necessary for a physical board, with additional precision delaying the point at which visible arms caused by approximation emerge.

Equal area needs square-root spacing

Angle alone does not produce uniform density. If each new LED moved outward by the same radial distance, the center would become tightly packed while large gaps opened near the edge. The reason is geometric: the area of a disc increases with the square of its radius.

Using `√n` for the radius gives each successive point a roughly equal share of the total board area. Evil Genius Labs reports that, in its comparison, the largest proximity cell was only about 1.3 times the smallest under square-root spacing. With equal radial steps, the largest cell was around 150 times the smallest. Moving outward faster or slower than the square-root rule shifts crowding toward the center or edge.

The layout also has practical advantages over grids and concentric rings. Square grids look complete at square-numbered counts, and rings look complete only when an outer ring is filled. A Fermat spiral remains a circular, visually balanced set as pixels are added one at a time. The same core rules can therefore support boards ranging from 32 to 1,024 LEDs with changes in physical spacing and component size rather than a new topology.

Fibonacci numbers appear when viewers trace the spiral arms. Connecting every third, fifth, eighth or thirteenth point reveals alternating families of curves because those ratios progressively approximate the golden-angle turn. The sequence is not an ornamental label added afterward; it emerges from the fractions that most closely approach the placement angle. That connection brings the electronic layout close to phyllotaxis, the natural arrangement of leaves and seeds that helps plants distribute repeated structures efficiently.